Dell Vostro 3591 With optical drive Service Manual - Page 37
Installing the heatsink, Removing the heatsink
View all Dell Vostro 3591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Installing the heatsink Steps 1. Place the heatsink on the system board and align the screw holes on the heatsink with the screw holes on the system board [1]. 2. In sequential order (as indicated on the heatsink), tighten the four captive screws that secure the heatsink to the system board [2]. Next steps 1. Connect the battery cable to the connector on the system board. 2. Replace the battery 3. Replace the base cover 4. Replace the SD memory card 5. Follow the procedure in after working inside your computer Removing the heatsink Prerequisites 1. Follow the procedure in before working inside your computer 2. Remove the SD memory card 3. Remove the optical drive assembly 4. Remove the base cover 5. Disconnect the battery cable from the connector on the system board. Steps 1. Loosen the four captive screws that secure the heatsink to the system board [1]. NOTE: Loosen the screws in the order of the callout numbers [1, 2, 3, 4] as indicated on the heatsink. 2. Remove the three (M2x3) screws that secure the heatsink to the system board [2]. 3. Lift the heatsink off the system board [3]. Removing and installing components 37