Dell Vostro 5301 Service Manual - Page 16

Installing the base cover, Steps

Get Dell Vostro 5301 PDF manuals and user guides View all Dell Vostro 5301 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Steps 1. Loosen the three captive screws that secure the base cover to the palm-rest and keyboard assembly. 2. Remove the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly. 3. Starting from the top-left corner, use a plastic scribe to pry the base cover in the direction of the arrows to release the base cover from the palm-rest and keyboard assembly. CAUTION: Do not pull on or pry the base cover from the side where the hinges are; doing so may damage the base cover. 4. Pry the base cover and remove it from the palm-rest and keyboard assembly. NOTE: The following steps are applicable only if you want to further remove any other component from your computer. 5. Using the pull tab, disconnect the battery cable from the battery. 6. Turn your computer over and press the power button for 15 seconds to drain the flea power. Installing the base cover Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the base cover and provide a visual representation of the installation procedure. 16 Disassembly and reassembly

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Steps
1.
Loosen the three captive screws that secure the base cover to the palm-rest and keyboard assembly.
2.
Remove the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
3.
Starting from the top-left corner, use a plastic scribe to pry the base cover in the direction of the arrows to release the base
cover from the palm-rest and keyboard assembly.
CAUTION:
Do not pull on or pry the base cover from the side where the hinges are; doing so may damage the
base cover.
4.
Pry the base cover and remove it from the palm-rest and keyboard assembly.
NOTE:
The following steps are applicable only if you want to further remove any other component from your computer.
5.
Using the pull tab, disconnect the battery cable from the battery.
6.
Turn your computer over and press the power button for 15 seconds to drain the flea power.
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the base cover and provide a visual representation of the installation procedure.
16
Disassembly and reassembly