Dell Vostro 5320 Service Manual - Page 39
Steps, To avoid damaging the display, do not slide the palm-rest and keyboard assembly over
![]() |
View all Dell Vostro 5320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Steps 1. Place the display assembly on a clean and flat surface with the display panel facing up. 2. Align and place the palm-rest and keyboard assembly under the display hinges. CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display assembly. 3. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the palm-rest and keyboard assembly. 4. Replace the two screws (M2x3) that secure the left-display hinge to the palm-rest and keyboard assembly. 5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the USB Type-C port bracket and the palm-rest and keyboard assembly. 6. Replace the two screws (M2x3) that secure the right-display hinge to the palm-rest and keyboard assembly. 7. Connect the display cable to the connector on the system board and close the latch to secure the cable. 8. Adhere the tape that secures the display cable to the system board. 9. Adhere the tape that secures the display-cable connector latch to the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. Removing and installing components 39
![](/manual_guide/products/dell-vostro-5320-service-manual-d6df0b3/39.png)