Dell Vostro 5490 Service Manual - Page 19
Solid state drive, Removing the M.2 2230 solid-state drive
![]() |
View all Dell Vostro 5490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Steps 1. Place the hard-drive module on the system and align the screw holes on the hard drive module with the screw holes on the palmrest assembly. 2. Replace the four (M2x3) screws to secure the hard-drive module to the palmrest assembly. 3. Connect the hard-drive cable to the connector on the system board and close the latch to secure the cable. Next steps 1. Install the battery. 2. Install the base cover. 3. Follow the procedure in After working inside your computer. Solid state drive Removing the M.2 2230 solid-state drive Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. 3. Remove the battery. About this task The figure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure. Removing and installing components 19
![](/manual_guide/products/dell-vostro-5490-service-manual-a8abb70/19.png)