Dell Vostro 5490 Service Manual - Page 42

Installing the power-adapter port

Get Dell Vostro 5490 PDF manuals and user guides View all Dell Vostro 5490 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

Installing the power-adapter port Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure. Steps 1. Locate the power-adapter slot on your computer. 2. Insert the power-adapter port into the slot on the system board. 3. Replace the single (M2x5) screw to secure the power-adapter port to the palmrest assembly. 4. Connect the power-adapter cable to the connector on the system board. 5. Close the left hinge. 6. Replace the three (M2.5x5) screws that secure the left hinge to the system board. Next steps 1. Install the battery. 2. Install the base cover. 3. Follow the procedure in After working inside your computer. 42 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
Installing the power-adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
1.
Locate the power-adapter slot on your computer.
2.
Insert the power-adapter port into the slot on the system board.
3.
Replace the single (M2x5) screw to secure the power-adapter port to the palmrest assembly.
4.
Connect the power-adapter cable to the connector on the system board.
5.
Close the left hinge.
6.
Replace the three (M2.5x5) screws that secure the left hinge to the system board.
Next steps
1.
Install the
battery
.
2.
Install the
base cover
.
3.
Follow the procedure in
After working inside your computer
.
42
Removing and installing components