Dell XPS One 2710 Owner's Manual (PDF) - Page 125
Replacing the Side-I/O Board, Procedure, Postrequisites
View all Dell XPS One 2710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
57 Replacing the Side-I/O Board WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in "Before You Begin" on page 11. After working inside your computer, follow the instructions in "After Working Inside Your Computer" on page 13. For additional safety best practices information, see the Regulatory Compliance Homepage at dell.com/ regulatory_compliance. Procedure 1 Align the screw holes on the side I/O-board with the screw holes on the computer base and gently insert the ports on the side I/O-board into the slots on the computer base. 2 Align the screw holes on the side I/O-board shield with the screw holes on the computer base and place the side I/O-board shield on the side-I/O board. 3 Replace the screws that secure the side I/O-board shield to computer base. NOTE: Ensure that you also secure the grounding cable with the same screw that secures the side I/O-shield to the computer base. Postrequisites 1 Follow step 1 to step 3 in "Replacing the System Board" on page 113. 2 Replace the processor heat-sink. See "Replacing the Processor Heat-Sink" on page 81. 3 Connect the antenna cables to the wireless mini-card. See "Replacing the Wireless Mini-Card" on page 69. 4 Follow step 3 to step 7 in "Replacing the I/O Board" on page 101. 5 Replace the inner frame. See "Replacing the Inner Frame" on page 97. 6 Replace the system-board shield. See "Replacing the System-Board Shield" on page 33. 7 Replace the I/O panel. See "Replacing the I/O Panel" on page 93. 8 Replace the trim cover. See "Replacing the Trim Cover" on page 89. 9 Replace the stand. See "Replacing the Stand" on page 49. 10 Replace the back cover. See "Replacing the Back Cover" on page 21. Replacing the Side-I/O Board | 125