Denon AVR 1909 Owners Manual - English - Page 29
Start Menu - test
UPC - 883795000444
View all Denon AVR 1909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications Auto Setup Optimize settings for speakers in use. a Start Menu The settings found at this stage are applied automatically. GAuto setup flowH Step 1: Speaker Detection Step 2: Measurement Step 3: Calculation Step 4: Check ENGLISH About the Auto Setup The Audyssey MultEQ auto setup function detects the presence of each speaker and automatically calculates the speaker size, channel level, distance, and optimal crossover frequency setting. Audyssey MultEQ corrects acoustical distortions within the listening area. Before starting, connect and position all of your speakers. Once started, MultEQ will play a series of test tones through each speaker. b Before starting Auto Setup (vq) If adjustment to the environment is necessary, set the following items before proceeding. n Front Speaker The front speaker to be measured can be selected ahead of time here. [Selectable items] A : Output test tone from front speakers A. B : Output test tone from front speakers B. A+B : Output test tone from front speakers A and B. Step 1 : Speaker Detection F Menu screen F q 1-1.Start Menu w Audyssey MultEQ Step1:Speaker Detection Auto Setup Please place microphone Audyssey MultEQ amtaienarlihsetiegnhitngatpositionS.tep1:SpeaFkreorntDeStpe.ctionYes Center Sp. Yes Front Sp. A Amp Assign Start Cancel Subwoofer Yes Surround Sp.Yes S.Back Sp. Yes 2spkrs Next Retry The speaker connection and polarity are detected at the first measurement position (main listening position). The following attributes are also determined at this time: "Speaker Size", "Speaker Distance", "Channel Level", "Crossover Frequency". q Select "Start 0", then press o. • Starts measuring the main listening position. w Select "Next 0", then press o. n To cancel Auto Setup Press ui to select "Cancel 0", then press o. Step 5: Store NOTE • Loud test sounds may be played during Audyssey MultEQ automatic speaker setup. This is part of normal operation. If there is background noise in room, these test signals will increase in volume. • Do not stand between the speakers and setup microphone or allow obstacles in the path while the measurements are being made. This will cause inaccurate readings. • Make the room as quiet as possible. Background noise can disrupt the room measurements. Close windows, silence cell phones, televisions, radios, air conditioners, fluorescent lights, home appliances, light dimmers, or other devices as measurements may be affected by these sounds. Cell phones should be placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use). • Operating MASTER VOLUME during the measurements will cancel the measurements. n Amp Assign Advanced setting : changes power amplifier assignment. You can use the surround back speaker for multi-zone, and for front channel bi-amp use. (Default : ZONE2) For details, refer to "Amp Assign" (vpage 35). • If an error message appears during the measurements, check "Error Messages", take the advised action, then start the measurements again (vpage 28). • If the result differs from the actual connection status or an error message appears, use i to on-screen display "Retry 0" and then press o to repeat the measurement. • If the result still differs from the actual connection status after re-measurement or the error message still appears, it is possible that the speakers are not connected properly. Turn the AVR-1909 off, check the speaker connections and repeat the measurement process from the beginning. NOTE Do not change the speaker connections or subwoofer volume after "Step 1".