Denon AVR 1909 Owners Manual - English - Page 57

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting Specifications Playback ENGLISH Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] PHONES jack [Front] [OFF] [QUICK SELECT] [SOURCE SELECT] [ON/SOURCE] [Rear] [SOURCE SELECT] [MASTER VOLUME] [MUTING] Preparations Operations During Playback Turning the Power On 1 Press . The power indicator lights red and the power is set to the standby mode. 2 Press or [ON/SOURCE]. The power indicator flashes green and the power turns on. b Also press SOURCE SELECT when in standby mode, the power turns on. In this case the input source is selected by remote control unit. b Also press [QUICK SELECT] when in standby mode, the power turns on. In this case Quick Select is selected. Adjusting the Master Volume Either turn or press [MASTER VOLUME]. [Variable range] - - - -80.0dB ~ 18.0dB NOTE The adjustable range will differ depending upon factors such as the type of input signal and the channel level setting. Turning Off the Sound Temporarily (Muting) Press [MUTING]. Turning the Power Off qPress or [OFF]. The power is set to the standby mode. wPress . The power indicator turns off, and so does the power. NOTE • Power continues to be supplied to some of the circuitry even when the power is in the standby mode. When leaving home for long periods of time or when traveling, either press to turn off the power, or unplug the power cord from the power outlet. • When the multi-zone power is switched on, and you want to switch off the main zone power, press [OFF]. • The sound is reduced to the level set at menu "Manual Setup" - "Option Setup" - "Volume Control" - "Mute Level". • To cancel, press [MUTING] again. Muting can also be canceled by adjusting the master volume. Listening with Headphones Plug the headphones into the PHONES jack on the main unit. The sound from the speakers and pre-out connectors is automatically cut. Selecting the Input Source Select the source using SOURCE SELECT. Turn or press [SOURCE SELECT] to switch between input sources. If "Rec Select" or "Video Select" is selected for the input source, press before turning . NOTE Be careful not to set the volume too high when using headphones. Switching the front speakers Press . Front A Front B Front A+B NOTE When you set to "Custom" with "Front Speaker Setup", you cannot operate (vpage 31).