Denon AVR-2311CI Owners Manual - English - Page 13
Parameter Check, Error messages
UPC - 883795001366
View all Denon AVR-2311CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH Error messages Parameter Check An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. This function enables you to check the measurement results and If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again. equalizer characteristics after Audyssey Auto Setup. NOTE Be sure to turn off the power before checking speaker connections. Examples AUTO SETUP AUDYSSEY AUTO SETUP MultEQ Caution! No microphone or Speaker Error details Measures • The connected setup microphone is broken, • Connect the included setup microphone to or a device other than the supplied setup the SETUP MIC jack of this unit. microphone is connected. • Not all speakers could be detected. • The front L speaker was not properly • Check the speaker connections. detected. Retry Check cause of problem! RETURN Cancel AUTO SETUP AUDYSSEY AUTO SETUP MultEQ Caution! Ambient noise is too high or Level is too low Retry • There is too much noise in the room for • Either turn off any device generating noise or accurate measurements to be made. move it away. • Perform again when the surroundings are quieter. • Speaker or subwoofer sound is too low for • Check the speaker installation and the accurate measurements to be made. direction in which the speakers are facing. • Adjust the subwoofer's volume. Check cause of problem! AUTO SETUP AUDYSSEY AUTO SETUP Caution! Front R None RETURN Cancel MultEQ • The displayed speaker could not be detected. • Check the connections of the displayed speaker. 1 Use ui to select "Parameter Check" and then press ENTER. 2 Use ui to select the item you want to check, then press ENTER or p. Measurement results for each speaker are displayed. AUTO SETUP PARAMETER CHECK Speaker Config Check Distance Check Channel Level Check Crossover Check EQ Check Restore Show speaker configuration result Speaker Config. Check Check the speaker configuration. Distance Check Check the distance. Channel Level Check Check the channel level. Crossover Check Check the crossover frequency. EQ Check Check the equalizer. • If "EQ Check" is selected in step 2, press ui to select equalizing curve ("Audyssey" or "Audyssey Flat") to be checked. Use o p to switch the display between the different speakers. Retry Check cause of problem! AUTO SETUP AUDYSSEY AUTO SETUP Caution! Front L Phase RETURN Cancel MultEQ 3 Press RETURN. The confirmation screen reappears. Repeat step 2. • The displayed is connected with the polarities • Check the polarities of the displayed speaker. reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ui to select "Skip", then press ENTER. Retrieving Audyssey Auto Setup settings If you set "Restore" to "Yes", you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ®) even when you have changed each setting manually. Retry Skip Check cause of problem! RETURN Cancel 10 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu