Denon DVD 3930CI Owners Manual - English - Page 27

ENGLISH Making the initial settings • When set to "50kHz" or "100kHz", you can enjoy the DTS recommended full range all-channel sound. (Note however that the subwoofer volume increases by 5 dB, or by 15 dB for Super Audio CDs.) In addition, the 6-channel sources of DVD-Audio discs recorded in the all-channel full range frequency model can also be played. In this case, make analog connections as described in the disc's instructions. • When setting "50kHz" or "100kHz", set all the speaker sizes to "LARGE" and the subwoofer to "YES". • The "CHANNEL LEVEL" and "DELAY TIME" settings remain in effect even when "50kHz" or "100kHz" is set. Setting the bass enhancer Sets the subwoofer output for when playing 2-channel or other sources without LFE signals. 1 Use [D H] to select "BASS ENHANCER", then press [ENTER]. 2 Use [D H] to select the item to be set, then press [ENTER]. OFF (Upon purchase): No sound is output from the subwoofer. ON: Sound is output from the subwoofer. Set "SUBWOOFER" at "SPEAKER CONFIGURATION" to "YES". 1 2 Making the initial settings Setting the dynamic range compression Use this procedure to set the dynamic range of the output signals when playing DVDs recorded in Dolby Digital. Dynamic range: This is the ratio between the softest sound that can be played without being drowned out by the noise generated by the equipment and the loudest sound that can be produced without the sound breaking up. 1 Use [D H] to select "COMPRESSION", then press [ENTER]. 2 Use [D H] to select the item to be set, then press [ENTER]. OFF (Upon purchase): The sound is played with the standard dynamic range. ON: Select this to achieve a powerful sound even when the volume is low. This setting is suited for use at night with the volume set low. 1 2 • This setting is only effective for analog outputs. • This setting is ineffective when "SOURCE DIRECT" is set to "50kHz" or "100kHz". 24 ENGLISH