Denon POA-3012CI Owners Manual - English - Page 20

Getting Started Connections Setup Operations Troubleshooting Specifications ENGLISH Operations ZONE operation mode indicators SELECT/ENTER Check the Status of Each Channel 1 Press the DISPLAY button. b Zone status is indicated on the bottom line of the display. b Turn the SELECT / ENTER knob to change the display as follows. Channel No. & INPUT Line VOLUME CONTROL level Operating the POA-3012CI Using a Browser (Web control) This function lets you operate the POA-3012CI using Internet Explorer. 1 Check the POA-3012CI's IP Address. "Network Setup" - "Network Information" (vpage 14) ON/STANDBY ZONE 5 DISPLAY u/ RETURN Turning the Power On Press the ON / STANDBY button. The power indicator flashes green and the power turns on. b The signal input to each channel is output from the speaker terminal of each channel. b The setting status of each channel is indicated on the display. b Turn the SELECT/ENTER knob to change the channel displayed. Output channel Input terminal CH 1&2 BUS L+R BTL 0.0dB OPERATION MODE Volume level (No display when in "NORMAL MODE") ZONE T.ON MODE LOW CUT FILTER 2 Press the DISPLAY button again. b System status is indicated on the bottom line of the display. b Turn the SELECT / ENTER knob to change the display as follows. POWER CONFIG DIMMER n To Return to the Regular Display Press the u / RETURN button until the display returns to normal. Other Operations Other Operations During Playback 2 Input the POA-3012CI's IP Address in Internet Explorer. For example, if the IP address is "10.3.18.90", enter http://10.3.18.90. 3 If the top menu is displayed, click "Setup Menu". Click 4 When the "Setup Menu" is displayed, click on the menu you want to operate. n To return to STANDBY Press the ON / STANDBY button again. The power indicator lights red. NOTE • When the "POWER CONFIGURATION" is set to "MASTER TRIGGER", the device will automatically enter the standby status when no trigger input is detected for a period of 10 minutes. • When the "POWER CONFIGURATION" is set to "ON LINE", send a standby command to the ETHERNET terminal or the RS-232C terminal of the POA-3012CI. • Power continues to be supplied to some of the circuitry even when the power is in the standby mode. When leaving home for long periods of time or when traveling, unplug the power cord from the power outlet.  n To Adjust the Volume Refer to "VOLUME CONTROL" on the "Main Setup" menu (vpage 13). n To Switch Input Setting Refer to "INPUT SELECT" on the "Main Setup" menu (vpage 13). n To Reduce the Low Frequency Volume Refer to "LOW CUT FILTER" on the "Main Setup" menu (vpage 13). Click the menu CHANNEL SETUP (vExample : 1) SYSTEM SETUP (vExample : 2) WARNING AND PROTECTION DATA (vExample : 3) AUDIO SIGNAL AND TRIGGER INPUT (vExample : 4) OPTION SETUP (vExample : 5) Click "SAVE" when you want to save settings, and click "LOAD" when you want to call settings. Becomes each operation screen.