Dewalt D27905H Instruction Manual - Page 5

English • compounds in insecticides, herbicides and pesticides, • arsenic and chromium from chemically-treated lumber. To reduce your exposure to these chemicals, wear approved safety equipment such as dust masks that are specially designed to filter out microscopic particles. SAVE THESE INSTRUCTIONS 5 percent of that shown on the specification plate on the tool. Several models, however, are designed for A.C. current only. Refer to the specification plate on your tool for proper voltage and current rating. Do not operate your tool on a current on which the voltage is not within correct limits. Do not operate tools rated A.C. only on D.C. current. To do so may seriously damage the tool. Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. FIG. A GROUNDED OUTLET GROUNDING PIN This appliance is for use on a nominal 120-volt circuit and has a grounding attachment plug that looks like the plug illustrated in Figure A. Make sure that the appliance is connected to an outlet having the same configuration as the plug. No adapter should be used with this appliance. Motor Many DEWALT tools will operate on either D.C. or single phase 25 to 60 cycle A.C. current and voltage within plus or minus SAVE THESE INSTRUCTIONS COMPONENTS (FIG. 1) WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. A. Hose wrap I. Carry handle B. Outlet for power tools J. Filter compartment C. Canister latch K. Filter door handle D. On/Off switch L. Cord wrap E. Variable suction dial M. Power cord F. Outlet activation switch N. Canister G. Twist-lock hose inlet O. Vacuum lid H. Suction hose INTENDED USE These vacuums are used for fine particulate pick-up, like drywall, concrete, wood or surface dust. These units come equipped with a built in outlet for use with power tools providing automatic vacuum start-up when tool is turned on and a 15-second vacuum overrun to clear suction hose when tool is turned off, dual filtration system, corrosion resistant tank, large wheels for easy maneuvering and a convenient flat top surface tray for holding tools while working. DO NOT use under humid conditions or in presence of flammable liquids or gases. These heavy-duty vacuums are for professional use. DO NOT let children come into contact with the tool. Supervision is required when inexperienced operators use this tool. 3