Dewalt DCP580B Instruction Manual - Page 16
assembly V, W, Z. Carefully remove
View all Dewalt DCP580B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English FIG. 11 W T S V R U FIG. 11A FIG. 12 W T S AA V R Z FIG. 12A HIGH-SPEED STEEL BLADE TU R V W FIG. 11B W S CARBIDE BLADE TZ AA R V W FIG. 12B W S V Y U X FIG. 11C V W AA Z Y X FIG. 12C 14 3. To Reinstall Blade (Fig. 10A, 10B) a. Cautiously remove the adjusted guide bar/high-speed steel blade assembly from the gauge plate (X) and place the heel of the guide bar (W) into the groove in the drum (T). b. Set the drum cover (S) over the adjusted guide bar/high-speed steel blade assembly and securely tighten the three star head screws (R) to the drum. 4. R epeat procedure for the other blade. NOTE: In order to use high-speed steel blades with this planer, the sharpening holder (BB) is required to sharpen highspeed steel blades and is available at additional cost from your local DeWALT authorized service center. REVERSIBLE CARBIDE BLADES (FIG. 12) 1. To Remove Blade from Planer (Fig. 12B) a. L oosen and remove the three star head screws (R) with the T25 star key (EE) provided. Remove the drum cover (S) from the drum (T). b. R emove the blade carrier/guide bar assembly (V, W, Z). Carefully remove the carbide blade (Z). 2. To Adjust Blade Using Gauge Plate (provided with tool) (Fig. 12C) a. C autiously place the sharp edge of the carbide blade (Z) on the gauge