Dewalt DWE46125 Instruction Manual - Page 8

English Fig. C 18 shroud button 8 at the same time to fully open the cutting shroud. Fig. E 8 7 4. Press the front shroud button 7 and the side shroud button 8 at the same time to fully open the cutting shroud. 5. Loosen the collar screw 2 on the cutting shroud and align the tabs 20 on the cutting shroud with the slots 21 on the grinder gear case. Fig. D 2 21 20 2. Remove the backing flange that is on the grinder (and keep it for conversion back to a grinder). 3. Install the backing flange, 12 or 14 , on spindle 25 . IMPORTANT: The DWE46125 comes with two sets of flanges. Refer to the Flange/Grinder Compatibility Chart at the end of this section for proper use. 4. Place the wheel 24 on the locking flange 11 or 13 , and place both on the spindle, against the backing flange, centering the wheel on the raised center of the backing flange. 5. While depressing the spindle lock button, tighten the locking flange using a wrench. 6. To remove the wheel, depress the spindle lock button and loosen the locking flange. Fig. F 11 6. Rotate the shroud into the desired working position. The shroud should be positioned between the spindle and the operator to provide optimum efficiency. 7. Tighten the collar screw 2 to secure the cutting shroud on the gear case. Do not operate the grinder with a loose cutting shroud. 8. To remove the cutting shroud, loosen the collar screw, rotate the cutting shroud to align the slots and tabs and pull up on the cutting shroud. NOTE: The cutting shroud is pre-adjusted to the diameter of the gear case hub at the factory. If, after a period of time, the cutting shroud becomes loose, tighten the collar screw 2 . Only adjust the collar screw when it is on the grinder otherwise the collar can be damaged. NOTICE: If cutting shroud cannot be secured by tightening the collar screw, do not use tool. Take the tool and cutting shroud to a service center to repair or replace the cutting shroud. Mounting and Using Type 1 (Cutting) Diamond Wheels (Fig. A, E, F)  WARNING: Only Type 1 Diamond Wheels shall be used with cutting shroud. Do not cut metal. Do not use with bonded abrasive wheels.  CAUTION: Do not use the shroud with the grinder flanges. Only use the shroud with the flanges provided with it. 1. With the cutting shroud attached to the grinder, press the front shroud button 7 and the side 24 12 25 Flange / Grinder Compatibility Chart Flange set Grinder Short (silver) flange set: Locking flange 11 Backing flange 12 DCG405, DCG413 6