Dewalt DWSL18CAP Instruction Manual - Page 12

English Cold Weather Operation WARNING: Read the section titled Important Safety Instructions at the beginning of this manual. Always wear eye and ear protection when operating this tool. Keep the stapler pointed away from yourself and others. For safe operation, complete the following procedures and checks before each use of the stapler. When operating tools at temperatures below freezing, complete preparation procedures outlined above and follow the directions below. 1. Make sure compressor tanks have been properly drained prior to use. Always drain the compressor tanks at least once daily while using the stapler. This is especially important in cold weather because any moisture in the air in the tanks will condense in the cold temperature. 2. Keep the tool as warm as possible prior to use. 3. Lower air pressure to 80 psi or less. 4. Actuate the tool 5 or 6 times into scrap lumber to lubricate o-rings. 5. Turn pressure up to operating level (not to exceed 120 psi) and use tool as normal. Hot Weather Operation Tool should operate normally. However, keep tool out of direct sunlight as excessive heat can damage bumpers, o-rings and other rubber parts. MAINTENANCE WARNING: Disconnect air line from tool and remove fasteners from magazine before making adjustments or personal injury may result. Daily Maintenance Chart ACTION Drain compressor tanks and hoses daily WHY Prevents accumulation of moisture in compressor and stapler HOW Open petcocks or other drain valves on compressor tanks. Allow any accumulated water to drain from hoses ACTION Clean magazine, pusher, and contact trip mechanism WHY Permits smooth operation, reduces wear, and prevents jams HOW Blow clean with compressed air. The use of oils or solvents is not recommended as they tend to attract debris ACTION Before each use, check to ensure all screws, nuts and fasteners are tight and undamaged WHY Prevents jams, leaks and premature failure of tool parts HOW Tighten loose screws or other fasteners using the appropriate hex wrench or screwdriver Cleaning WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. 10