Dewalt DWSL18CAP Instruction Manual - Page 7

English • Do not drive fasteners blindly into FIG. U walls, floors or other work areas. Fasteners driven into live electrical wires, plumbing, or other types of obstructions can result in injury. (Fig. U) • Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. WARNING: ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT: • ANSI Z87.1 eye protection (CAN/CSA/Z94.3), • ANSI S12.6 (S3.19) hearing protection, • NIOSH/OSHA/MSHA respiratory protection. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE Tool Specifications MODEL DWSL18CAP DESCRIPTION 18 Gauge Cap Stapler ENGINE TYPE Oil-Free OPERATION PRESSURE RANGE 70-120 psi (4.9 to 8.43 kg/cm2) MAXIMUM OPERATION PRESSURE 120 psi (8.43 kg/cm2) AIR CONSUMPTION AT A RATE OF 60 FASTENERS PER MINUTE * 2.68 cfm (75.9 lt/min) @ 80 psi (5.6 kg/cm2) FASTENER CROWN SIZE 5/16" (7.9 mm) FASTENER GAUGE 18 Gauge FASTENER RANGE 1" to 1-1/2 (25 mm - 38 mm) MAGAZINE CAPACITY Up to 160 Staples LENGTH 11-3/4" (298 mm) WIDTH 7.0" (178 mm) HEIGHT 11-3/4" (298 mm) WEIGHT 5.02 lb (2.28kg) The DWSL18CAP requires 2.68 cubic feet per minute or cfm (75.9 liters per minute or lt/min) of free air at 80 psi (5.6 kg/cm2) to operate at a rate of 60 fasteners per minute. To determine the appropriately sized air compressor, take the actual rate at which the tool will be run and compare the required cfm (lt/min) to the compressors free air delivery (cfm/ lt/min) at 80 psI (5.6 kg/cm2). 5