Dynex DX-L37-10A User Manual (English) - Page 7

4 TV components Note: You must pay attention to the direction of the stand on the 37" TV. The wide portion of the stand should go towards the front of the TV. TV components Front Table edge 4 To remove the stand from the TV, perform these steps in reverse order. Installing a wall-mount bracket If you want to attach the TV to a wall-mount bracket (not provided), you should first remove the stand column. To remove the stand column: 1 Lay your TV face down on a table or bench. Make sure that you put down a soft cushion or cloth so that your TV is not scratched. Remove four screws # Component Description 1 Remote sensor Receives signals from the remote control. Do not block. 2 Power indicator Lights blue when your TV is turned on. Lights red when your TV is in standby mode. Side Remove the stand column Stand column 2 Remove the four screws holding the stand column to your TV, then remove the stand column. Note: The appearance of this product in these illustrations may differ from your actual product, and is for comparative purposes only. To attach your TV to a wall-mount bracket: Warning: These servicing instructions are for use by qualified service personnel only. To reduce the risk of hazards, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. 1 Remove the four screws holding the TV to its base, as described above. 2 Remove the TV base. 3 Secure the wall-mount bracket to the back of your TV using the four M6 screws provided with the bracket. # Component Description 1 CH /CH 2 VOL /VOL Press to go to the next or previous channel in the channel list. Press to increase or decrease the volume. 3 MENU Press to open the on-screen menu. 4 INPUT Press to select the video input source. 5 (Power) button Press to turn on your TV. Press again to put your TV in standby mode.