Dynex DX-L40-10A User Manual (English) - Page 7
Installing and removing the, stand - support
View all Dynex DX-L40-10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
DX-L40-10A_09-0537_MAN_ENG_V1.book Page 4 Tuesday, July 28, 2009 10:07 AM 4 DX-L40-10A Installing and removing the stand Installing and removing the stand You must install your TV into the stand for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV on a wall or other vertical surface, you must remove the stand column. Warning: Before attempting assembly or removal of the stand, unplug the AC power cord. Cautions: Read these instructions thoroughly before attempting this installation. Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of your ability to do this, or to use the tools necessary to complete this job, refer to a professional installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or improper assembly. When using a table or bench as an aid to assembly, make sure that you place the TV on a soft cushion or covering to prevent accidental scratching or damage to your TV's finish. The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can cause damage to your TV that is not covered by the manufacturer's warranty. Installing the stand To install the stand: 1 Remove the stand from the box and place it on a table or bench. 2 Lay your TV flat, screen down, on a clean, flat, stable surface, such as a tabletop. Make sure that you place it on a soft cushion or cloth so that your TV is not scratched. 3 Align the base with the bottom of the TV, then secure the base to the TV with the four M6XL 16 mm screws provided. 4 Set your TV upright on a stable surface. Removing the stand To remove the stand from the stand column: 1 Lay your TV face down on a table or bench. Make sure that you place it on a soft cushion or cloth so that your TV is not scratched). 2 Remove the four M6XL 16 mm screws securing the base to the TV, then remove the base. Installing a wall-mount bracket If you want to attach the TV to a wall-mount bracket (not provided), you should first remove the stand pedestal if it is pre-attached (see above). To attach your TV to a wall-mount bracket: Warning: These servicing instructions are for use by qualified service personnel only. To reduce the risk of hazards, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. • Secure the wall-mount bracket to the back of your TV using the four screws provided with the bracket. • To convert the 400 x 200 to a 200 x 200 wall mounting hole size, secure the two horizontal bracket adapters using two screws in the accessory kit.