Dynex DX LCD32 User Manual (English) - Page 5

Setting up your TV 5 # Button Description 16 ENTER Press the arrows to move down, up, left, or right in the on-screen menu. Press the ENTER button to confirm changes or to toggle options on and off in the on-screen menu. 17 MENU Press to open the on-screen menu. 18 FAVORITE Press to toggle the Favorite/Normal mode. See "Setting up the channel list" on page 7 for more information. 19 VOL + or - Press to adjust the volume up or down. 20 - Use with the 0-9 number buttons and ENTER key to select digital channels. 21 [Number buttons] Press to enter channel numbers. In the on-screen menu, press to enter your parental control's password. 22 COMP Press to select Component source mode. 23 VIDEO Press to toggle between S-Video and Composite source modes. 24 INPUT Press to select the video input signal source. 25 DISPLAY Press to display status information. Using the remote control To use the remote control: • Point the remote control towards the remote sensor on the front of your TV. Notes • Do not expose the remote control to shock or liquids. • Do not use the remote control in an area with high humidity. • Do not place the remote control in direct sunlight. • Do not place objects, such as furniture, between the remote control and the remote sensor. • The remote control may not work if direct sunlight or bright light shines on the remote sensor. Either move your TV or change the angle at which you use the remote control. Setting up your TV Installing remote control batteries To install the remote control batteries: 1 Remove the battery cover. 2 Insert two AAA batteries into the battery compartment. Make sure that you match the + and - symbols on the batteries with the + and - symbols in the battery compartment. 3 Replace the cover. Notes • Do not mix batteries of different types. • Do not mix old and new batteries. • Remove batteries when the charge is depleted. • Battery chemicals can cause a rash. If the batteries leak, clean the battery compartment with a cloth. If chemicals touch your skin, wash immediately. • If the remote control is not going to be used for an extended period of time, remove the batteries. Connecting your TV to a power outlet To connect your TV to a power outlet: • Plug the power cord into a power outlet. Notes • • Make sure that you use the correct type of power. See the label on your TV. If you do not intend to use your TV for an extended period of time, unplug the power cord from the power outlet. Connecting an outside antenna Antenna cables come in two types: 75 ohm and 300 ohm. 75 ohm cable 300 ohm cable • If your antenna cable has a 75 ohm connector, connect the cable to the coaxial jack on the back of your TV. • If your antenna cable has a 300 ohm connector, connect the cable to a 300-75 ohm adapter (not included), connect the adapter to a 75 ohm cable, then connect the other end of the 75 ohm connector to the coaxial jack on the back of your TV. Connecting cable TV Your TV has a 75 ohm jack for connecting cable TV. Some cable TV providers scramble the signals for "premium" (pay) channels. To view these channels, you need a converter/descrambler box. If you do not have a converter/descrambler box, you can connect your cable TV directly to your TV. If you have a converter/descrambler box, you can connect your cable TV using an RF switch (not supplied). For more information about connecting a converter/descramble box, contact your cable TV provider. To connect cable TV without a converter/descrambler box: 1 Connect one end of a 75 ohm cable to the coaxial jack on the back of your TV. 2 Connect the other end of the cable to the cable TV wall outlet.