Electrolux EI28BS56IB Use and Care Guide - Page 9
To adjust the flipper mullion
UPC - 012505747786
View all Electrolux EI28BS56IB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation 9 4 Lift the door while adjusting the washer. To raise the door, rotate washer clockwise (when viewed from the bottom). To lower door, rotate washer counter-clockwise (when viewed from the bottom). To adjust the flipper mullion: 1 Loosen the set screw located on the flipper mullion hinge. Raising/Lowering Door 5 Re-tighten the set screw, ensuring it is between the spokes of the set washer. Set screw will not be tight, just insert until it is flush with the hinge. Adjusting Flipper Mullion Screw 2 Adjust flipper mullion height. For proper connection with the flipper mullion guide, there should be a separation about the thickness of a coin (0.060 inches, or 1.5 mm) between the guide and flipper mullion. Set Screw NOTE If after adjusting doors higher the door makes a popping/clicking sound, remove set screw and replace with a longer one. Adjusting Flipper Mullion Height 3 Re-tighten set screw.