Electrolux EI30GF35JS Complete Owner's Guide (English) - Page 39
Setting self-clean, CAUTION, Setting delayed self-clean
View all Electrolux EI30GF35JS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Self-clean 39 Setting self-clean (cont'd) Setting delayed self-clean To cancel self-clean: 1. Press thecancel key. 2. If the self-clean cycle has heated the oven to a high temperature, "Hot" (Figure 1) will show in the display. Allow enough time for the oven to cool and for the "door OPn" message to display (Figure 2). When this message turns OFF the oven door may be opened. You may wish to set your appliance to perform a self-clean cycle later (up to 12 hours later). The end time key will determine when the cleaning will stop. You will need to set the end time far enough to allow for the type of clean cycle you choose, whether for 2, 3, or 4 hours. Remember to add 30 to 40 additional minutes of cooling time before using the oven for cooking. Setting for a heavy (4 hour) self-clean cycle to end at 8:00 o'clock: Example Fig. 1 Fig. 2 Starting self-clean after cancelling: If a self-clean cycle was cancelled using the cancel key before the oven was finished cleaning, you may wish to set for another self-clean cycle. If self-clean was cancelled shortly after being started, and the oven interior did not reach high self-clean temperatures, the next clean cycle may be set as soon as the oven door unlocks from the cancelled clean cycle. Step 1. Be sure the clock is set with the correct time of day. Remove all oven racks. Remove all items from the cooktop. Be sure the oven door is completely closed. 2. Press end time. Press 3. Enter 8 0 0 using the numeric keypad. If the oven became hot enough from the cancelled self-clean cycle, you may be required to wait up to 4 hours before the control will allow another selfclean cycle to start. Restarting a self-clean cycle after a power outage: If the self-clean cycle was interrupted by a power failure, your oven may not be thoroughly cleaned. Another self-clean cycle may be needed. Once power is restored, the oven has cooled and the oven door has unlocked, set to clean for another cycle. Setting repeated self-clean cycles If attempting to set repeating self-clean cycles, the control may display the messages "CLEAn"" then "dELAy" followed by the length of time before the next self-clean may be set. For example, if the message displayed reads "4:00", and the time is 12:00 o'clock, the control will not allow self-clean to be set again until after 4:00 o'clock. 4. Press START. 5. Press self clean. 6. Press self clean again. 7. Press START. Press CANCEL at any time to stop self-clean. CAUTION To avoid possible burns use caution when opening the oven door after the self-clean cycle is finished. The oven may still be VERY HOT. Stand to the side of the oven when opening the door to allow hot air or steam to escape.