Epson ActionNote 866C User Manual - Page 53
Using Your Computer, Both of these drivers are loaded in your computer's
View all Epson ActionNote 866C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Note If you are using an ATA hard disk or ATA flash card, make sure your CONFIG.SYS file contains this command: DEVICEHIGH=C:\CARDSOFT\ATADRV.EXE If you are using an SRAM card, make sure the CONFIG.SYS file contains this command: DEVICEHIGH=C:\CARDSOFT\MTSRAM.EXE Both of these drivers are loaded in your computer's CONFIG.SYS file at the factory. The following table describes the removable storage card utilities. ATA utility commands Command Function ATAINIT* Partitions the ATA card and identifies its physical parameters: then you can use MS-DOS FORMAT to format the drive. ATADRV Assigns the next available drive letter to the ATA drive. When you start your system, you see a message identifying the drive letter assigned to the drives in your PCMCIA slots. MTDDRV Displays the drive letter for SRAM and ATA cards. Since these cards share drive letters, it is important to know where these cards are installed. * This command works only with ATA cards that are supported by the ATADRV driver. 2-18 Using Your Computer