Epson C414014 User Manual - Page 9

Using Different Paper Widths, notch and down to the shaft, as shown below.

Get Epson C414014 - TM L90 Color Thermal Line Printer PDF manuals and user guides View all Epson C414014 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

English . Using Different Paper Widths The TM-L90 accommodates 80 mm wide paper rolls with no adjustments. For rolls from 38 mm to 70 mm wide you use the spacer included with the printer. (If the rolls are from 61 to 70 mm wide, you break two tabs off the spacer. See the width note below.) 1. Insert the paper roll spacer so that the front edge goes through the notch and down to the shaft, as shown below. notch front edge roll paper spacer 2. Push the paper roll spacer until you feel it click onto the shaft. Note: Check that the paper roll spacer slides smoothly to the left and right. shaft inside edge of the spacer 3. Slide the roll paper spacer to the appropriate width, as shown above. You can use the measurement printed inside the printer, aligning the inside edge of the spacer with the desired measurement. TM-L90 User's Manual 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
TM-L90 User’s Manual
7
English
.
Using Different Paper Widths
The TM-L90 accommodates 80 mm wide paper rolls with no
adjustments. For rolls from 38 mm to 70 mm wide you use the spacer
included with the printer. (If the rolls are from 61 to 70 mm wide, you
break two tabs off the spacer. See the width note below.)
1.
Insert the paper roll spacer so that the front edge goes through the
notch and down to the shaft, as shown below.
2.
Push the paper roll spacer until you feel it click onto the shaft.
Note:
Check that the paper roll spacer slides smoothly to the left and right.
3.
Slide the roll paper spacer to the appropriate width, as shown
above. You can use the measurement printed inside the printer,
aligning the inside edge of the spacer with the desired
measurement.
notch
front edge
roll paper
spacer
shaft
inside edge of
the spacer