Epson CX5400 Start Here Card - Page 5

7 Install Software and Connect to Your Computer The software works with Windows® 98, Me, 2000, and XP, and Macintosh® OS 8.6 to 9.2.2 and 10.2.x. Follow the steps below (for Windows), or the steps in the next column (for Macintosh). Windows 1 Make sure the Stylus CX is not connected to your computer, then turn on your computer. Note: If your Stylus CX is turned on and connected to your computer, you may see several New Hardware Wizard screens. Click Cancel for each of these screens and disconnect your Stylus CX. You can't install your software that way. 2 Insert your Stylus CX CD-ROM in your CD-ROM or DVD drive. 3 When you see the message about disabling your antivirus software, click Continue. 4 Read the license agreement, then click Agree. The Software Installation screen opens automatically. 5 Click Install. Note: If the install screen doesn't open automatically, do the following: For Windows XP: click Start > My Computer. Then double-click the EPSON CD-ROM icon. For Windows 2000/Me/98: double-click My Computer. Then double-click the EPSON CD-ROM icon. 6 When you see this screen, make sure your Stylus CX is turned on, then remove the sticker from the USB port. 7 Connect the flat end of the USB cable to any available USB port on your computer. 8 Connect the Stylus CX USB port. square end of the USB cable to your After you connect your Stylus CX, Windows displays several messages as it detects your device. If you don't see the messages, make sure your Stylus CX is turned on. continue