Epson EMP S5 User Guide - Page 39
Power indicator lights red, Status, Cause, Remedy or Status, Problem - filter
UPC - 010343864054
View all Epson EMP S5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Problem Solving 39 f t Power indicator lights red Status Red Red Red Red Cause Internal Error Fan Error Sensor Error Problem : Lit : Flashing: : Off Remedy or Status Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries Red High Temp Error The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector Red (overheating) switches to standby mode, so check the following two points. • Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. • If the air filter is clogged, clean or replace it. s p.50, 56 Red If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.30 Lamp Error Red Lamp Failure Check the following two points. • Take out the lamp and check if it is cracked. s p.53 Red Lamp Cover Open • Clean the air filter. s p.50 If it is not cracked - Re-fit the lamp and turn on the power. If the error continues - Replace the lamp with a new lamp and turn on the power. If the error continues - Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries If it is cracked - Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced). sInquiries Check that the lamp cover and the lamp are securely installed. s p.53 If the lamp cover or the lamp is not securely installed, the lamp does not switch on. When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.30