Epson ES-1200C User Setup Information - PC - Page 9

Connecting The Scanner To The Computer

Get Epson ES-1200C PDF manuals and user guides View all Epson ES-1200C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Connecting the Scanner to the Computer Use this procedure to connect the scanner directly to the SCSI port on your computer using the cable included in the scanner package. If you are already using the SCSI port on your computer for another SCSI device, such as an external hard drive, see Chapter 1 of the ES-1200C User's Guide for information on including the scanner in a daisy-chain arrangement. Caution: Be sure that your computer, scanner, and any other peripheral devices are turned off before you plug in the cables. 1. Connect the 50-pin end of the cable to either the top or bottom SCSI connector of the scanner; then fasten the connector with the clamps on the sides of the connector, as shown. 2. Plug the other end of the interface cable into the connector of the SCSI interface card you installed in the computer. Fasten the connector with the wire clamps.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
Connecting the Scanner to the Computer
Use this procedure to connect the scanner directly to the SCSI
port on your computer using the cable included in the scanner
package.
If you are already using the SCSI port on your computer for
another SCSI device, such as an external hard drive, see
Chapter
1
of the
ES-1200C User’s Guide
for information on
including the scanner in a daisy-chain arrangement.
Caution:
Be sure that your
computer,
scanner, and any other peripheral
devices are turned off before you plug in the cables.
1.
Connect the 50-pin end of the cable to either the top or
bottom SCSI connector of the scanner; then fasten the
connector with the clamps on the sides of the connector, as
shown.
2.
Plug the other end of
the
interface cable into the connector
of the SCSI interface card you installed in the computer.
Fasten the connector with the wire clamps.