Epson PowerLite 735c Product Information Guide - Page 10

EPSON PowerLite 735c Projector 6. To customize transitions between slides, click the cell or cells you want to set up. (To select more than one cell, hold down the Ctrl key while you click.) Then right-click the selected cell(s) in the scenario window and click Cell Properties. Choose from any of the following options: ❏ Select On mouse click if you want to change slides manually using the remote control. ❏ If you want your slides to advance automatically, click Automatically after, then set a length of time between 1 and 1800 seconds (30 minutes). Even if you select this setting, you can still change slides manually using the remote control. ❏ To add a transition effect such as a dissolve or fade, select one of the Animation Effects and choose a Direction, if applicable. Then click OK to close the cell Properties window. 7. Click Save. Then continue with the steps in the next section to transfer your scenario to a memory card. Transferring the Scenario to a Memory Card Before you start, make sure you're set up to access the card in your computer's PCMCIA slot or card reader. Follow the procedure below to make sure the scenario plays properly. Note: You have to save the scenario on your computer's hard drive before transferring it. Don't use Windows to copy the scenario to your memory card, or it may not play properly. 1. From the Scenario Option menu, choose Send Scenario. You see a drive selection window. 2. Choose the drive where your card is located, then click OK. 3. Click OK again to confirm. Your scenario is transferred to the card. You see this message: 4. Do one of the following: ❏ If you don't want the scenario to run automatically whenever the projector is turned on (with the memory card in the projector), click Cancel. Then remove the card from your computer and insert it in the projector. ❏ To run the scenario automatically when the projector is turned on, click OK. On the Edit Autorun window, select the scenario from the list on the left and use the arrow button to move it to the Autorun Scenario List on the right. Click OK when you're done, and then remove the card from your computer and insert it in the projector. Note: If more than one scenario is set to run automatically, they will play in the order listed in the Autorun Scenario List. Projector Status Lights s Power light Lamp/temperature light The lights on top of the projector indicate the projector's status and let you know when a problem occurs. Power light Green Flashing green Orange Flashing orange - - Lamp/ Description and action Temperature light Off The projector is operating normally. Off The projector is warming up. Wait for the image to appear. Off The projector is in standby mode. You can unplug it or press the P Power button to turn it on. Off The projector is cooling down. Wait for the light to stop flashing before unplugging it. Flashing orange The projector is too hot. Make sure the room temperature is not above 95 °F and there is plenty of space around and under the projector for ventilation. Also, the air filter may be clogged. Clean or replace it, as described on page 11. Flashing red* Power is cut off because of an internal error in the projector. Unplug the projector and contact EPSON. 10 - EPSON PowerLite 735c Projector 2/03