Epson PowerLite 81p Product Information Guide - Page 13
Resetting the Lamp Timer, Warning, Caution
View all Epson PowerLite 81p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5. Use the screwdriver to loosen the two screws holding the lamp in place. (You can't remove the screws.) Epson PowerLite 61p/81p Projector 9. Lower the lamp cover into place. (The opening should be almost covered, and the top of the lamp cover should be flush with the surface of the projector.) Then slide the cover closed and tighten the screw. Don't remove these screws 6. Hold the lamp as shown and pull it straight out. Warning: This product includes a lamp component that contains mercury (Hg). Please consult your state and local regulations regarding disposal or recycling. Do not put it in the trash. 7. Gently insert the new lamp. If it doesn't fit easily, make sure it's facing the correct way. 8. Once the lamp is fully inserted, tighten its screws. 10.Reset the lamp timer as described in the next section. Resetting the Lamp Timer You must reset the lamp timer after replacing the lamp to clear the Replace the Lamp message. Note: Do not reset the lamp timer if you have not replaced the lamp. If you do, the Lamp Hours will not accurately reflect the number of hours that the lamp has been used. 1. Connect the power cable and turn on the projector. 2. Press the Menu button on the remote control and select the Reset menu. Then press Enter. You see the following: 3. Select Lamp-Hours Reset and press Enter. You see the following: Caution: Do not touch the glass portion of the lamp assembly. Touching the glass could result in premature lamp failure. 6/04 Epson PowerLite 61p/81p Projector - 13