Epson R1900 Product Information Guide - Page 9
Loading Roll Paper, behind the roll and marked with
UPC - 010343866058
View all Epson R1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Epson Stylus Photo R1900 Series Loading Roll Paper You can load roll paper or canvas media for printing large images, panoramic images, or multiple photos, with or without borders. You can load roll paper or canvas media in these widths: ❏ 8.3-inches wide ❏ 13-inches wide Tip: It's a good idea to check the ink status and replace cartridges, if necessary, before loading roll paper. This is because you must remove roll paper from the printer before replacing cartridges to avoid ink marks on the paper. 1. Turn on the printer. 2. Remove any paper loaded in the sheet feeder and remove the single sheet guide, if it is installed. Also close the paper support. 3. Open the output tray, but do not pull out the extensions. 6. Insert the left roll paper holder (marked with a down orange triangle) into the far left slot on the back of the printer (marked with a right orange triangle). Then insert the other roll paper holder in the corresponding slot on the right. 7. Feed the end of the paper into the roll paper feeder, located behind the roll and marked with the M roll paper icon. Then slide the roll paper edge guide against the right side of the paper, but not too tightly. 4. Place the roll paper holders on each end of the paper roll as shown. 5. Remove any tape and protective paper from the end of the roll and make sure the corners of the paper are cut at 90° angles to avoid paper feeding problems. Note: Avoid touching the surface of your paper or canvas media. With canvas media that you have previously loaded, it's a good idea to cut the edge straight each time you reload it. 90° Caution: Do not load roll paper or canvas media into the manual feed slot (marked with up orange triangles). 8. Guide the paper into the slot and hold it for a few seconds until the printer feeds in the paper automatically. Note: When loading canvas media, leave two to three inches of slack in the roll as it feeds and prints for the best results. If you have trouble feeding canvas media, check that the edge is straight and reload it, making sure to keep the roll slack. 9. Open the printer cover and look into the printer to make sure the roll paper or canvas media is feeding straight. The paper must feed straight so the printer can properly identify the edge of it. 11/07 Epson Stylus Photo R1900 Series - 9