Epson WF-5690 Users Guide - Page 316
Solving Setup Problems, Noise After Ink Installation, Software Installation Problems
View all Epson WF-5690 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 316 highlights
• Copy Settings: Resets all settings for copying. • Scan Settings: Resets all settings for scanning. • Fax Settings: Resets all settings for faxing. • Clear All Data and Settings: Resets all control panel settings to their defaults and deletes the contacts list. You see a confirmation screen. 6. Select Yes to reset the selected settings. (Select No if you want to cancel the operation.) Parent topic: Solving Problems Solving Setup Problems Check these sections if you have problems while setting up your product. Noise After Ink Installation Software Installation Problems Parent topic: Solving Problems Noise After Ink Installation If you hear noises from your product after installing ink, check the following: • The first time you install the ink cartridges, the product must charge its print head. Wait until charging finishes before you turn off the product, or it may charge improperly and use excess ink the next time you turn it on. • If the product's print head stops moving or making noise, and the charging process has not finished after approximately 5 minutes, turn off your product. Turn it back on and check to see if charging is still in progress. If it is still in progress, contact Epson for help. Parent topic: Solving Setup Problems Software Installation Problems If you have problems while installing your product software, try these solutions: • Make sure your product is turned on and any necessary cables are securely connected at both ends. If you still have problems installing software, disconnect the cable and carefully follow the instructions on the Start Here sheet. Also make sure your system meets the requirements for your operating system. • Close any other programs, including screen savers and virus protection software, and install your product software again. 316