Fluke P3011-MMHG Product Manual - Page 24
Piston Re-Assembly, Replacement PCU Assembly, The piston and cylinder assembly is a matched pair
View all Fluke P3011-MMHG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
P3000 Series Users Manual W Caution Never touch the working surface of a clean piston with bare fingers - the natural oil in your skin can cause the piston and cylinder to stick. 8. Wipe any dirt or moisture from the outside surfaces of the cylinder (2). 9. Roll a NEW tissue into a tapered rod of appropriate size. Force the tissue through the cylinder bore while rotating. Ensure that the tissue is a tight fit inside the bore so that dirt and contamination is removed. 10. Repeat step 9 using a NEW tissue but from the opposite end of the cylinder. 11. Immerse the cylinder in a suitable, clean solvent, see note in step 5 above. 12. After removal from the solvent, using a NEW tissue, repeat the cleaning procedure in step 9 and 10. Piston Re-Assembly 13. Holding the piston by the larger "head" end, carefully introduce the piston into the underside of the cylinder, and push gently through (the piston will normally slide freely through due to its own weight). Never force the piston into its cylinder or damage will result. If resistance continues, re-clean piston, cylinder, or both. If, after repeated cleaning, the piston still will not slide freely within the cylinder, then permanent damage may have occurred. In which case, the parts should be returned to the factory for evaluation or replacement. 14. Stand assembly upright on a clean, hard, stable surface, ensure that the weight carrier (1) is clean (especially the central mounting hole), and place on the tapered end of the piston. Tap lightly using the palm of the hand to locate on the taper. 15. Carefully screw the assembly into the instrument, ensuring that the seal (6) is clean and undamaged, and correctly re-fitted. Replacement PCU Assembly W Caution The piston and cylinder assembly is a matched pair, which is calibrated and adjusted to a calculated mass figure. If, for any reason, the piston or cylinder becomes damaged, then the entire assembly must be replaced. The replacement assembly consists of the following components: Item numbers 1 through 3. 5-2 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664