Frigidaire FPEF3077QF Complete Owner's Guide - Page 14
Caution, Warning, Important
View all Frigidaire FPEF3077QF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
BEFORE SETTING OVEN CONTROLS Oven Vent Location Type of oven racks The oven is vented as shown below. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Do not block oven vent. Never close off the openings with aluminium foil or any other material. Steam or moisture may appear near the oven vent. This is normal. oven vent location flat handle oven rack offset oven rack Figure 8: Oven rack types Oven Rack Descriptions Figure 7: Do not block oven vent location CAUTION Always use pot holders or oven mitts when using the oven. When cooking, the oven interior and exterior, oven racks, and cooktop will become very hot which can cause burns. WARNING Protective Liners - Do not use aluminum foil to line the oven bottom. Only use aluminum foil as recommended in this manual. Improper installation of these liners may result in risk of electric shock or fire. IMPORTANT • Flat oven racks (or the flat handle oven rack) may be used for most cooking needs and may be placed in most oven rack positions. • The offset oven rack (some models) provides additional step down positions from the standard flat rack design. The offset design positions the base of the rack about ½ of a rack position lower than the flat rack and may be used in most oven rack positions. Removing, replacing, and arranging flat or offset oven racks To arrange - Always arrange the oven racks when the oven is cool (prior to operating the oven). To remove - Pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide out. To replace - Place the oven rack on the rack guides on both sides of oven walls. Tilt the front of oven rack upward slightly and slide the oven rack back into place. Be sure oven racks are level before using. All oven racks should be removed before a self clean operation. Racks left in the oven during the high heat of the self clean function can easily discolor. The ability of the racks to easily slide in and out along the rack positions may also be affected. CAUTION IMPORTANT Do not line the oven walls, racks, bottom or any other parts of the range with aluminum foil. Doing so will alter heat distribution and may cause permanent damage to the oven interior. During self clean the oven temperatures will be hot enough to melt foil. Remove all oven racks and clean according to instructions provided in the Care & Cleaning section of this manual. Never pick up hot oven racks or parts. 14