Fujitsu MAP3367NC Manual/User Guide - Page 7
Important Alert Items - connection
UPC - 000004119623
View all Fujitsu MAP3367NC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Important Alert Items Important Alert Messages The important alert messages in this manual are as follows: Task Mounting Installation A hazardous situation could result in minor or moderate personal injury if the user does not perform the procedure correctly. This alert signal also indicates that damages to the product or other property may occur if the user does not perform the procedure correctly. Alert message Page Data loss 2-5 For MAP series, Reed Solomon codes are applied for their ECC. The sector-data is divided into 6 interleaving sectors, and ECC is performed in each sector where the maximum number of errors (up to 5 byte) can be corrected. [Total maximum byte: 5 byte × 6 ( interleave) = 30 byte] If the error of read sector keeps allowable error byte number, correction is performed. However, if error byte exceeds its allowable number, correction may not be performed properly. Hot temperature To prevent injury, do not handle the drive until after the device has 5-1 cooled sufficiently after turning off the power. The DE and LSI become hot during operation and remain hot immediately after turning off the power. Data loss 1. The user must not change the setting of terminals not described 5-5 in this section. Do not change setting status set at factory shipment. 2. Do not change the setting of terminals except following setting pins during the power is turned on. • Write protect: CN2 9-10 (NP model only) 3. To short the setting terminal, use the short plug attached when the device is shipped from the factory. Damage 5-11 1. Make sure that system power is off before connecting or disconnecting cables. 2. Do not connect or disconnect cables when power is on.(except NC model) C141-E166 v