Fujitsu XG2600 Hardware Guide - Page 22

XG2600 Hardware Guide 1.1.4 Switch Port Side PSU Slots for Rear-Access Installation Port1 SFP+ Slots Chapter 1 Getting Started Serial Port Reset Switch Port25 PSU1 Power Supply Unit Power Inlet Port2 PSU2 Power Supply Unit Port26 USB Port Management Port • PSU Slots for Rear-Access Installation PSUs are plugged in the slots when the switch is used in Rear-Access configuration. • Power Inlet Plug the attached Power Cable in the package. • Power Supply Unit This switch is installed with two PSUs. • SFP+ Slots Plug SFP+ modules for connecting Ethernet based networking equipment (10GBASESR/10GBASE-LR). Port number is assigned from the upper side of the leftmost port to the right. For example, Port 1 is the upper side of the leftmost port, and Port 26 is the lower side of the right most port. • Reset Switch Press to reboot. • USB Port Insert a USB memory device to load/save configuration files or update firmware. • Serial Port (Console Connection) The Serial Port is used to connect the switch with the console (PC) for setting and command line interface via the attached console cable adapter (RJ45 to Serial Adapter) and RS232C crossover cable (D-SUB9). Caution Serial Port is only used for connecting the switch with RS-232C interface of the console. Do not connect other interfaces such as LAN/ISDN which cause an error. Reference User's Guide "1.1.5 Console Port Specifications" (pg.29) • Management Port This is used to connect Ethernet based (10/100BASE-TX) networking equipment. Use Category-5 LAN cables. The Management Port is MDI fixed. If you connect the device that have MDI fixed port to the Management Port, please use the Crossover Cable. 22 Items in the Package, Descriptions and Functions