Fujitsu XG2600 Hardware Guide - Page 38
Fujitsu XG2600 Manual
View all Fujitsu XG2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
XG2600 Hardware Guide Chapter 2 Installation 2.2.3 Change Switch Access Configurations from Rear-Access (Factory Default) to Front-Access and Install This section describes how to change Rear-Access configuration (Factory Default) to Front-Access. Note For Front-Access configuration to Rear-Access, make the procedure reversed. Remove rack mounting brackets 1. Remove rack mounting brackets attached to the sides of the switch. XG2600 Rack Mounting Brackets Change the direction of fans to adjust airflow Change the direction of fans, depending on which switch access configuration to go with, Rear-Access or Front-Access. Check the direction of fans before installing the switch in the rack. Airflow is as shown below. • Rear-Access Configuration (Factory Default) Exhaust Intake • Front-Access Configuration Intake Airflow Label Airflow Label Exhaust 38 Installation of the switch