Fujitsu XG2600 Hardware Guide - Page 35
Rear-Access Configuration (Factory Default), Decide positions for rack mounting brackets
View all Fujitsu XG2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
XG2600 Hardware Guide 2.2.2 Rear-Access Configuration (Factory Default) This section describes how to install switch in Rear-Access configuration (Factory Default). Chapter 2 Installation Decide positions for rack mounting brackets 1. Decide positions of rack mounting brackets. It is possible to install the switch either in a standard front position of the rack or in an offset position of the rack. In case to locate the switch offset from the front side, change the positions of rack mounting brackets. [STANDARD] XG2600 [OFFSET] XG2600 Rack Mounting Brackets Plug into the hole of the device. 35 Installation of the switch
XG2600 Hardware Guide
Chapter 2 Installation
Installation of the switch
35
2.2.2
Rear-Access Configuration (Factory Default)
This section describes how to install switch in Rear-Access configuration (Factory Default).
Decide positions for rack mounting brackets
1.
Decide positions of rack mounting brackets.
It is possible to install the switch either in a standard front position of the rack or in an offset position of the rack.
In case to locate the switch offset from the front side, change the positions of rack mounting brackets.
[STANDARD]
Rack Mounting Brackets
[OFFSET]
Plug into the
hole of the device.