Ganz Security PT112N PT112N/ Manual - Page 17

OPERATION 3 Check Points before Operation z Before power is applied, please check the cables carefully. z The camera ID of the controller must be identical to that of the target camera. The camera ID can be checked by reading DIP switch of the camera. z If your controller supports multi-protocols, the protocol must be changed to match to that of the camera. z If you changed camera protocol by changing DIP switch, the change will be effective after you reboot the camera. z Since the operation method can be different for each controller available, refer to the manual for your controller if camera can not be controlled properly. The operation of this manual is based on the standard Pelco® Controller. Preset and Pattern Function Pre-Check z Check controller or DVR preset and pattern functions in advance when using controller or DVR. z Refer to the following table when using standard Pelco® protocol controller. < Go Preset > < Set Preset > < Run Pattern > < Set Pattern > Input [Preset Number] and press [Preset] button. Input [Preset Number] and press [Preset] button for more than 2 seconds. Input [Pattern Number] and press [Pattern] button. Input [Pattern Number] and press [Pattern] button for more than 2 seconds. z If controller or DVR has no pattern button or function, use shortcut keys with preset numbers. For more information, refer to "Reserved Preset" in this manual. Speed Dome Camera Instruction Manual 17