Garmin Dakota 10 Owner's Manual - Page 43

Attaching a Carabiner, Lanyard, Mount, or Other Optional Accessory, Calibrating the Touchscreen - instructions

Get Garmin Dakota 10 - Touchscreen Handheld GPS Navigator PDF manuals and user guides
UPC - 753759094867
View all Garmin Dakota 10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Attaching a Carabiner, Lanyard, Mount, or Other Optional Accessory 1. Position the accessory in the slots on the mounting spine of the Dakota. Accessory (carabiner) Clip Mounting spine 2. Slide the clip up until it locks in place. To remove the clip, lift the bottom of the clip and slide the clip off the mounting spine. Appendix Calibrating the Touchscreen The Dakota screen does not normally require calibration. However, if the buttons do not seem to be responding properly, use the following process. To calibrate the touchscreen: 1. While the unit is turned off, press and hold for approximately 30 seconds. 2. Follow the instructions on the screen until "Calibration is complete" is displayed. Dakota Series Owner's Manual 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Dakota Series Owner’s Manual
³·
Appendix
Attaching a Carabiner,
Lanyard, Mount,
or Other Optional
Accessory
1. Position the accessory in the
slots on the mounting spine of the
Dakota.
Accessory
(carabiner)
Clip
Mounting
spine
2. Slide the clip up until it locks in
place.
To remove the clip, lift the bottom
of the clip and slide the clip off the
mounting spine.
Calibrating the
Touchscreen
The Dakota screen does not normally
require calibration. However, if the
buttons do not seem to be responding
properly, use the following process.
To calibrate the touchscreen:
1. While the unit is turned off, press
and hold
for approximately 30
seconds.
2. Follow the instructions on the
screen until “Calibration is
complete” is displayed.