Garmin GPS III Plus Owner's Manual - Page 101
Using Simulator for Faster Data Transfer - uploading waypoints
UPC - 753759015817
View all Garmin GPS III Plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
RAM Failed-The GPS III+ has detected a failure in its internal memory. If the message persists, the GPS III+ is unusable and should be taken to an authorized GARMIN service center. Received Invalid Waypoint-A waypoint was received during upload transfer that has an invalid identifier. Receiver Failed-A failure in receiver hardware has been detected. If this message persists, do not use the unit and take it to an authorized dealer for repair. ROM Failed-The permanent memory has failed and the unit is not operable. Take your unit to an authorized GARMIN dealer for repairs. Route Already Exists-You have attempted to name a route with the same name currently in use with an existing route. Enter a different name for the route. Route Full-You have attempted to add more than 30 waypoints to a route. Route Memory Full-Route memory is full and no additional routes can be added from another GPS III+ or uploaded from a PC. Route Waypoint Deleted-The waypoint being deleted was part of a route. The deleted waypoint is removed from waypoint memory and from the route. RTCM Input Failed-DGPS data being received has been lost. You are no longer receiving the beacon signal. APPENDIX E Searching the Sky- The GPS III+ is in Messages searching the sky for almanac data or the unit is in AutoLocate mode. Steep Turn Ahead-This message appears approximately one minute prior to a turn that requires a bank angle in excess of 25 degrees in order to stay on course. Stored Data Lost-All waypoints, routes, time, and almanac data have been lost due to battery failure, or the receiver's memory has been cleared. Timer Expired-The countdown timer has expired. Track Log Already Exist-The name selected for the track log is identical to another track log already stored in memory. Track Memory Full-You have used all track log points in the GPS III+. (The unit holds approximately 1900 points in the active track log.) Delete unwanted track points to make room for new entries. Using Simulator for Faster Data Transfer-While using the PC Software Kit or the MapSource program, simulator mode is automatically selected to enable a higher data transfer rate. Waypoint Memory Full-You have used all 500 waypoints in the GPS III+. Delete unwanted waypoints to make room for new entries. Waypoint Already Exists-The name you are entering already exists in the GPS III+'s memory. 91