GE DSXH47EGWW Owners Manual - Page 21

Troubleshooting Tips - error codes

Get GE DSXH47EGWW - 5.8 cu. Ft. Electric Dryer PDF manuals and user guides
UPC - 084691158943
View all GE DSXH47EGWW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support Error Codes If the dryer stops, the status lights flash and the signal beeps, an error has occurred. Press PAUSE/CANCEL. Consult the Error Code Chart below for the possible cause and solution. Make the correction, select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please contact service for assistance. Error Code, Error 4 beeps, Dryer ran too long 6 beeps, Push button does not function Possible Causes Lint filter blocked, ventilation system clogged or dryer overloaded Push button held too long or wedged in the control panel What To Do • Remove lint; wash the lint filter to remove softener sheet residue. Clean out the ventilation system. Reduce load size. • Press buttons lightly and release. Disengage the button. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
21
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Error Code, Error
Possible Causes
What To Do
4 beeps, Dryer ran
Lint filter blocked, ventilation
•
Remove lint; wash the lint filter to remove softener sheet
too long
system clogged or dryer
residue. Clean out the ventilation system. Reduce load
overloaded
size.
6 beeps, Push button does
Push button held too long or
•
Press buttons lightly and release. Disengage the button.
not function
wedged in the control panel
Error Codes
If the dryer stops, the status lights flash and the signal beeps, an error has occurred. Press PAUSE/CANCEL. Consult the
Error Code Chart below for the possible cause and solution. Make the correction, select a cycle and press START. If the
dryer stops, status lights flash again and the beeping continues, please contact service for assistance.