GE GSM2260VSS Installation Instructions - Page 3
Installation Preparation-Enclosure - parts
View all GE GSM2260VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Preparation-Enclosure PREPARE DISHWASHER ENCLOSURE AND SINK LOCATION • Water line to sink faucet and drain from sink can be run through Area "A." • Hot water line to dishwasher is installed in Area "B." • Garbage disposer, water lines to faucet, waste trap, air gap and water shut-off valve are installed in a 12" wide cabinet, Area "C". Countertop: 1-1/2" Min. Thick 10-1/4" Max. Area "A" 7-1/2" Front View Area "C" • Sink opening for garbage disposer must be dimensioned as shown (7-1/2") in Area "C." This will provide clearance for disposer and plumbing in Area "C" when using either single or double bowl sink. Refer to Figure A below and Figure F1 on page 6. 3/4" Min. 20-1/2" Max. Sink Bowl 11" Min. Drain Wall 1" Max. To Sink Flange 1-1/4" Min. I.R. 6" Max. 10-1/4" MAX. A PLUMBING DEPTH 34-1/4" +_1/4" 1-1/2" 11-3/4" Max. Plumbing Close Elbow Dishwasher Side View 6" Max. Toekick Area 4" Max. B Area "B" 24" 12" Min. Floor Figure A 24" Min. Cabinet PREPARE CABINET CUTOUT FOR SINK: WARNING To reduce the risk of shock, fire, or injury to persons, the installer must ensure that the 923-38C dishwasher is completely enclosed at the time of installation. ADVERTENCIA Para reducir el riesgo de choque, incendio o lesión a personas, el instalador se debe cerciorar de que la lavadora esté #282 French completamente cerrada en el momento de la instalación. • The cabinet opening must have a minimum width and depth of 2647" a9nDd hiaeiAght of 34-1/4" ± 1/4". • This dishwasher fits under a special sink with a depth of 6" or less in a 1-1/2" countertop. • The dishwasher must be fully enclosed on the top, sides and back. • The dishwasher must not support any part of the enclosure. Wall 20-1/2" Max. Sink Bowl Tub Front Flange 24" min Figure B Sink Installation Cutout 5" 5" 8" X 20" Adjacent Cabinet Rear Cutout 12-1/2" 3-1/4" 12" Cabinet Side Adjacent to D/W 24" min Gap Dishwasher 24" Min. Cabinet Note: A gap between the dishwasher tub front flange and the front of the base cabinet may result due to either the cabinet being less than 24" deep or the sink bowl 679DiaK not being installed to specifications. If the gap is more than 3/4", the sink bowl must be relocated to meet specified dimensions. 3