GE JN328KSA Installation Instructions - Page 11

INSTALLATION INSTRUCTIONS Installation Instructions 2 REMOVE EXHAUST ADAPTOR  ,IH[KDXVWLQJYHQWLQJXVLQJWKH UHFWDQJXODUGXFW²RSWLRQDOIRU-9 JV248, JV338, JV347, JV348, JV367 and AV447 models only: Remove the exhaust adaptor from the inside of the hood. Set it aside along with its mounting screws. 31ø4s x 10s rectangular exhaust adaptor and screws 3 REMOVE FILTER Remove the shipping tape holding the metal grease filter in place. Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back. 5 REMOVE WIRING COVER Remove the wiring cover from inside the hood. Set the cover and its mounting screws aside. Wiring cover 6 REMOVE WIRING KNOCKOUT Remove either the top or the back wiring knockout as needed and install an approved strain relief clamp. Top Back knockout knockout Strain relief clamp Strain relief clamp Metal grease filter 4 REVERSE THE BAFFLE FOR DUCTED INSTALLATIONS ONLY (JV247, JV248, JV347, JV348, JV367 and AV447 models) If the hood is to be recirculated, skip to the next step. Remove the baffle from the top of the hood. Reinstall the baffle so the short side marked "VENTED" is visible. The long side of the baffle should be inside the hood. "VENTED" is visible 7 REMOVE DUCT KNOCKOUT If recirculating, non-vented ductless (JN327, JN328 and RN328, and optional for JV247, JV248, JV347, JV348, JV367 and AV447 models only), skip to Step 11 D and proceed. Using a flat-blade screwdriver, remove the appropriate duct knockout from the top or back of the hood. 31ø4s x 10s Rectangular vertical discharge. Remove top rectangular duct knockout only. 7s Round vertical discharge. Remove circular duct knockout only. 49-80589-6 31ø4s x 10s Rectangular horizontal discharge. Remove rear rectangular duct knockout only. 11