GE JN328KSA Installation Instructions - Page 6

USING THE HOOD: Controls / CARE AND CLEANING: Filters Controls Throughout this manual, features and appearance may vary from your model. Control Knobs (on some models) Switch Pad Controls (on some models) ON HI OFF LO HI MED 1 OFF ON NITE 2 OFF OFF LO 1 2 OFF HI OFF ON 1. LIGHT Control: Press the pad at the top to turn MED NITE LO the light ON. 2. Fan Settings Buttons: Press the pad at the top to turn the fan on HI and at the bottom to turn it on LO. The center position is OFF. 1 (AV447 models only) 2 Continuous use of the fan system while cooking helps keep the kitchen comfortable and less humid. 1. FAN Control: Turn to HI, MED or LO as needed. It also reduces cooking odors and soiling moisture that create a frequent need for cleaning. Continuous use of the fan system while cooking helps keep the kitchen comfortable and less humid. It also reduces cooking odors and soiling moisture that create a frequent need for cleaning. 2. LIGHT Control: Turn to ON while cooking or to NITE for use as a night light. Filters Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood. 5HXVDEOH0HWDO*UHDVH)LOWHU³'XFWHG,QVWDOODWLRQV2QO\ The efficiency of your hood depends on a clean filter. Frequency of cleaning depends on hood use and the type of cooking you do. However, the grease filter should be cleaned at least once a month. To remove: Pull down on the center of the front edge of the filter. The filter will then slip out of the retaining tabs on the back. NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE. With careful handling, the metal filter will last for years. If a new replacement filter becomes necessary, order the part from your dealer. Order genuine GE part number WB02X8391. To replace: Slip the back edge of the filter into the retaining tabs and push the front edge up until it snaps into place. To clean: Soak and then agitate it in a hot water and detergent solution. Light brushing can be used to remove embedded dirt. Rinse, shake and let it dry before replacing. Grease filter 6 49-80589-6