GE JN328KSA Installation Instructions - Page 14

INSTALLATION INSTRUCTIONS Installation Instructions 14 SCREW IN PART WAY Drive a mounting screw (from the hardware packet) part way into each center of the narrow neck of the keyhole slots marked on the cabinet bottom. 15 OPTIONAL POWER CORD KIT JXHC1 An optional Power Cord Connection Kit, model JXHC1, is available at extra cost from your GE supplier for installation using a standard 3-prong, grounded wall outlet. Follow the Installation Instructions packed with the kit to connect the power cord to the range hood. CL Cabinet 17 SECURE HOOD Slide the hood back against the wall. Tighten the mounting screws. Be sure the screw heads are in the narrow neck of the keyhole slot. Mounting screw (4) Keyhole (4) NOTE: DO NOT PUSH ON THE FAN BLADE. Pushing on the blade may cause it to interfere with other hood parts. 73ø4s 11ø4s 3-prong wall outlet (if using cord connection) 13ø4sdia. clearance hole for optional power supply location NOTE: If using optional Power Cord Kit JXHC1, feed the power cord through the hole in the top cabinet while raising the hood. Loop any excess length of cord and tie away with a suitable tape or tie. 16 FEED IN WIRES Lift the hood into position and feed the house wiring through the wiring knockout. 17 CONNECT DUCTWORK TO HOOD (Ducted installations only) 2QƎURXQGLQVWDOODWLRQVDWWDFKWKHƎGXFW with sheet metal screws through the holes in the alignment ears. 7s round duct Attachment ear tabs Use duct tape to make joints secure and airtight. Duct tape 14 49-80589-6