GE PDT760SSJSS Installation Instructions - Page 14
Step 20: Dishwasher Wet Test, Step 21, Replace Floor Protect, On Some Models, Step 22: Position
View all GE PDT760SSJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Dishwasher Installation STEP 20: DISHWASHER WET TEST • Turn on power supply or plug power cord into outlet, if equipped. • Select a cycle to run and push the Start button. • Ensure the door is latched. Dishwasher should start. • Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on. • Check for leaks under the dishwasher. If a leak is found, turn off power at the breaker, and then tighten water connections. Restore power after leak is corrected. • Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against DGMDFHQWFDELQHWV5HSRVLWLRQWKHGLVKZDVKHULIQHFHVVDU\ See Step 13. • Press and hold the Start button for 3 seconds to cancel the cycle. The unit will begin to drain. Check drain lines. If leaks are found, turn off power at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Steps 7, 8, 9, 10 and 17. • Open dishwasher door and make sure all of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. Also check drain hose to be sure it is not kinked underneath or behind dishwasher. See Step 17. • Press Start button once again and run dishwasher through another cycle. Check for leaks and correct if required. • Repeat this step as necessary. STEP 22: POSITION INSULATION, PRETOEKICK, AND SOUND BARRIER (on some models) Skip this step if the sound insulation package is not supplied with the dishwasher. • Locate the sound insulation package and pre-toekick packages inside the dishwasher. • Stand the parts upright as shown. Dishwasher Door Toekick Figure AF Sound barrier (On some models. Part is already attached to door.) PreToekick (On some models.) Panel (On some models.) • Locate the control box. Control Box Insulation Block (On some models.) Figure AG • Push insulation block portion under the dishwasher until it is beneath the control box. STEP 21: REPLACE FLOOR PROTECT (on some models) • Slide Floor Protect under dishwasher. • Angle the rear back edge of the Floor Protect upwards to engage mounting tabs. • Lift front of drip tray and secure with 2 screws. • Connect leak sensor connector to leak sensor. Leak sensor Figure AE Floor Protect (on some models) Figure AH • Push the panel portion up to the front of the block. Push the sides of the insulation behind the toekick attachment screw holes • Tuck the sides of the front panel behind the toekick attachment screw holes. • Open door all the way, if the door doesn't stay fully open, DGMXVWWKHLQVXODWLRQSDQHO • On models so equipped, position pre-toekick over the insulation. Align the screw holes with the screw holes on the legs of the dishwasher. WARNING: :KHQUHLQVWDOOLQJWKHÀRRUSURWHFWSDQPDNHFHUWDLQWKDWWKH screws have been fully secured. This will ensure that if the unit is SURSHUO\JURXQGHGWKDWWKHÀRRUSURWHFWSDQZLOODOVREHJURXQGHG 14