GE PDT760SSJSS Installation Instructions - Page 7
Dishwasher Installation
View all GE PDT760SSJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Dishwasher Installation STEP 5: IF NECESSARY, REMOVE FLOOR PROTECT (on some models) • Disconnect leak sensor wire (on some models). • Remove 2 screws from front of the Floor Protect with a ¼" driver. • Lower front of pan and slide out from under dishwasher. • Set aside for use in Step 21. Squeeze connector at top to release snap feature Leak Sensor Floor Protect Figure L STEP 8: POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. 4" 4" 6" 6" Water House Line Wiring Figure O STEP 6: INSTALL 90° ELBOW • Thread 90° elbow onto the water valve. Ensure rubber gasket is located between valve and elbow. Water Valve Bracket • Do not overtighten elbow. Water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the rear of the dishwasher. Figure M Front of dishwasher 90° Elbow Fill Hose STEP 7: INSTALL DRAIN HOSE TO DRAIN LOOP Connect drain loop end to drain hose using the screw clamp as shown in the figure. Figure N NOTE: The high drain loop on the side of the tub is designed for better wash performance. Do not remove from the side of the tub. STEP 9: INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate cabinet opening. Insulation Blanket House Wiring Power Cord (If used) Water Line Drain Hose Ensure drain hose is not twisted or pinched Maximum drain hose length is 15' Do not disconnect or remove high drain loop from left side of dishwasher Figure P 7LS3UHYHQWXQQHFHVVDU\VHUYLFHFDOOFKDUJHVIRU¿OOGUDLQ or noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 7