GE PDT760SSJSS Installation Instructions - Page 9

Dishwasher Installation STEP 13: PUSH DISHWASHER INTO FINAL POSITION • Check the tub insulation blanket, if equipped, to be sure it is smoothly wrapped around the tub. It should not be "bunched up" and it must not interfere with the door springs. If the insulation is "bunched up" or interfering with the springs, straighten and recenter the blanket prior to sliding the dishwasher into its final position. • Slide the dishwasher into the final position by pushing on the sides of the door panel. Do not push or pull the door in a partially open or closed position when moving the dishwasher. Do not use a knee or push on the center of the panel. If you do, damage to the panel will likely result. Check that the dishwasher is squarely positioned in the cabinet opening at both the top and the bottom of the appliance prior to mounting to the cabinet. IMPORTANT - Before opening the dishwasher door, be certain the edges of the dishwasher door panel are behind WKHIDFHRIWKHDGMDFHQWFDELQHWDQGQRWXSDJDLQVWWKHFDELQHW face. Refer to Figure U. If the dishwasher door is opened when the edge of the door is against the face of the cabinet, dishwasher door damage and cabinet damage will occur. • Open and close the dishwasher door to be sure it operates VPRRWKO\DQGGRHVQRWUXERQWKHDGMDFHQWFDELQHW  Door Fits and Swings Back Behind Cabinet Frame Correct Alignment Figure U Incorrect Alignment Door Catches will result in door damage on Cabinet Frame Tip: Prevent unnecessary service charges for panel damage or wash performance. Check dishwasher alignment prior to opening dishwasher door to prevent panel damage. Make sure utility lines are not trapped or crushed behind dishwasher. Crushed lines will restrict water flow. Check that tub trim does not contact the door at all points Do not allow tub trim to get trapped by or come into contact with the door Top View Tub frame Tub trim Door Handle Tub trim may be trimmed if necessary to ensure proper door operation Top View Tub trim trapped E\GRRU 9