Gigabyte GA-965P-DS3 Manual - Page 13

English Internal Connectors Š 3 USB 2.0/1.1 connectors for additional 6 ports by cables Š 1 S/PDIF In connector Š 1 power LED connector Š 1 Chassis Intrusion connector Rear Panel I/O Š 1 PS/2 keyboard port Š 1 PS/2 mouse port Š 1 S/PDIF Out connection (coaxial+optical) Š 1 parallel port Š 1 serial port Š 4 USB 2.0/1.1 ports Š 1 RJ-45 port Š 6 audio jacks (Line In / Line Out / MIC In/Surround Speaker Out (Rear Speaker Out)/Center/Subwoofer Speaker Out/Side Speaker Out) I/O Control Š IT8718 chip Hardware Monitor Š System voltage detection Š CPU/System temperature detection Š CPU/System/Power fan speed detection Š CPU warning temperature Š CPU/System/Power fan failure warning Š CPU Smart Fan Control BIOS Š 1 8 Mbit flash ROM Š Use of licensed AWARD BIOS Š PnP 1.0a, DMI 2.0, SM BIOS 2.3, ACPI 1.0b Additional Features Š Supports @BIOS Š Supports Download Center Š Supports Q-Flash Š Supports EasyTune (Note 3) Š Supports Xpress Install Š Supports Xpress Recovery2 Š Supports Xpress BIOS Rescue Bundle Software Š Norton Internet Security (OEM revision) Form Factor Š ATX form factor; 30.5cm x 21.0cm (Note 1) Applies only when the GA-965P-DS3/S3 motherboard (rev. 3.3) is installed with a 1333 MHz FSB processor. The system will automatically adjust BIOS to support 1333 MHz FSB by overclocking when a 1333 MHz FSB processor is installed. In such a configuration, the actual operating memory frequency will be 667 MHz or 833 MHz, depending on the memory being installed. (Note 2) To use a DDRII 800/667 memory module on the motherboard, you must install a 1333/1066/ 800 MHz FSB processor. (Note 3) EasyTune functions may vary depending on different motherboards. - 13 - Hardware Installation