Gigabyte Z490M GAMING X User Manual - Page 18

9) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. •• PLED/PWR_LED (Power LED, Yellow/Purple): PLED+ PW+ Power LED Power Switch Speaker System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state SPEAK- SPEAK+ NC NC PW- PLED- or powered off (S5). 2 20 1 19 •• PW (Power Switch, Red): Connects to the power switch on the chassis front panel. You may PWR_LED- PWR_LED- PWR_LED+ CI+ RES+ HD- configure the way to turn off your system using the power switch CI- RES- HD+ (refer to Chapter 2, "BIOS Setup," "Settings\Platform Power," for more Hard Drive Activity LED Reset Switch Power LED Chassis Intrusion Header information). •• SPEAK (Speaker, Orange): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED, Blue): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch, Green): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header, Gray): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been removed. This function requires a chassis with a chassis intrusion switch/sensor. •• NC (Orange): No Connection. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. 10) F_AUDIO (Front Panel Audio Header) The front panel audio header supports High Definition audio (HD). You may connect your chassis front panel audio module to this header. Make sure the wire assignments of the module connector match the pin assignments of the motherboard header. Incorrect connection between the module connector and the motherboard header will make the device unable to work or even damage it. Pin No. Definition Pin No. Definition 9 1 1 MIC2_L 6 Sense F_ U F_ 2 GND 7 FAUDIO_FJ_D 10 2 3 MIC2_R 4 NC 8 No Pin 9 LINE2_L 5 LINE2_R 10 Sense Some chassis provide a front panel audio module that has separated connectors on each wire instead of a single plug. For information about connecting the front panel audio module that has different wire assignments, please contact the chassis manufacturer. B SS B_ 1 1 - 18 - 1 _S 1 _ SS B S_