Haier AB122MCERA Operation Manual - Page 10
Operation, instruction
View all Haier AB122MCERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Operation instruction ON/OFF operation CM COOL 11723 1 OPERATION HIGH MODE FAN SWING HEALTH • TEMP • 2gt ROOMTEMP. CLOCK ionu.l 0I37 CLOCK • TIME • TIMER SET RECOVERY CHECK C=0= FILTER ) 1 RESET 0 ON/OFF O 2 Press ON/OFF switch on line controller directly 4 The line controller displays the running state 5 in the latest time (timing and swing state may not be displayed). 3 1. Press "ON/OFF" switch. The air conditioner starts operating, and the light on the wired controller is on. 2.Choose operation mode. Press "mode"switch to change to "AUTO"---"FAN ONLY"---"COOL"---"DRY"--- "HEAT". 1 3.Press "TEMP" switch 6 Change set temperature:press TEMP A or TEMP V every time, [SET] will display, and set temperature will increase/reduce lt 4.Press "FAN SPEED" switch FAN ONLY Operation: Press "FAN SPEED" switch to change to "HIGH"--"MED"--"LOW"--"HIGH" In AUTO,COOL,DRY,HEAT Operation: Press "FAN SPEED" switch to change to "AUTO"--"HIGH"--"MED"--"LOW"--"AUTO" 5.Press "SWING" switch on the line controller to swing the wind screen. 6.Press "ON/OFF"switch, off. The light on the line controller is off. Note Several seconds after the operation of the line controller, the setting of the unit will change. Remarks • Avoid pressing "ON/OFF" switch frequently. Do not press line controller or switches by sharp objects. • The temperature is on the basis of the setting value. The wind temperature may not reach the setting value because of the outer air conditioner and system protection. • When the wired controller is power on, the screen fully displays it for two seconds. and clock • zone "8888"-"888"-"88"-"8" flicker for 30 seconds. All the switches are invalid at the time. 8